Difference between revisions of "White Dwarf"
Jump to navigation
Jump to search
| (2 intermediate revisions by the same user not shown) | |||
| Line 28: | Line 28: | ||
|- | |- | ||
|Mass flow rate | |Mass flow rate | ||
|0.803 kg/s (0.625 N2O, 0. | |0.803 kg/s (0.625 N2O, 0.134 IPA, 0.044 water) | ||
|} | |} | ||
</center> | </center> | ||
[[File: | ==Resources== | ||
* [[:File:WHITE DWARF.pdf|Overall Drawing]] | |||
[[File:WD Cross Section With Gussets.png|thumb|400x400px|Cutaway of the White Dwarf CAD.]] | |||
[[File:White Dwarf Mounting Face.png|thumb|400x400px|Outside view of the White Dwarf CAD.]] | [[File:White Dwarf Mounting Face.png|thumb|400x400px|Outside view of the White Dwarf CAD.]] | ||
==Combustion Chamber== | ==Combustion Chamber== | ||
The [[White Dwarf Combustion Chamber|combustion chamber]] uses a water-cooled jacket, with a graphite nozzle. The cooling channels are cut into an off-the-shelf copper tube using a CNC machine. | The [[White Dwarf Combustion Chamber|combustion chamber]] uses a water-cooled jacket, with a graphite nozzle that is bolted into a retainer ring. The cooling channels are cut into an off-the-shelf copper tube using a CNC machine. | ||
==Injector== | ==Injector== | ||
The [[White Dwarf Injector|injector]] is intended to be a pintle design. | The [[White Dwarf Injector|injector]] is intended to be a pintle design. | ||
Latest revision as of 00:28, 14 August 2022
Overview
White Dwarf is a scaled down test version of the White Giant engine that is intended to launch Panthera. The operating parameters are shown in the table below:
| Oxidiser | Nitrous oxide (N2O) |
| Fuel | 75% Isopropyl alcohol (IPA, C3H8O), 25% water (by mass) |
| Thrust | 1.5 kN |
| Chamber pressure | 10 bar |
| Chamber temperature | 2857 K |
| O/F ratio | 3.5 (by mass - where the water is included in the 'fuel' mass) |
| Specific impulse | 190 s (theoretical) |
| Mass flow rate | 0.803 kg/s (0.625 N2O, 0.134 IPA, 0.044 water) |
Resources
Combustion Chamber
The combustion chamber uses a water-cooled jacket, with a graphite nozzle that is bolted into a retainer ring. The cooling channels are cut into an off-the-shelf copper tube using a CNC machine.
Injector
The injector is intended to be a pintle design.